2014 Mobius LSV Surf Wave

[mnpracing]

just make sure the IBS is pulled forward before you start to fill it to prevent the cup holders from popping. I think I also used to put part of a pool noodle there to keep the IBS forward.

[csm]

just make sure the IBS is pulled forward before you start to fill it to prevent the cup holders from popping. I think I also used to put part of a pool noodle there to keep the IBS forward.

Yup, pulling the IBS forward works, but you have to do it each time. It works it's way back for some reason. Haven't tried to put anything like a noodle in front of it, but that's a great idea.

[jstenger]

I just pulled the cupholders. I know someone on the forum actually made a plate to cover the holes. I don't think he had the center bow cushion.

[nitrodude24]

Is there enough room in the rear locker to fill the 1100 lb right full ? we have a 900LB and it fills the locker up pretty well doesn't look like theres a whole lot of extra space. Also when we fill our IBS right full it pops the front cup holders out have you had this problem ? if so how did you fix it ?

I think the 1100s fit better on newer LSVs because of the taller decks. The lockers and everything got deeper. I run 1100s and have no issues.

[13mobiusLSV]

So how many of you guys with the 1100s reinforce your rear lockers?

[Stephen]

What kind of reinforcement does it need? I've got my 1100 coming tomorrow.

[13mobiusLSV]

What kind of reinforcement does it need? I've got my 1100 coming tomorrow.

Mandley has a thread on here who reinforced his walls and did a "how to". Wake makers says no need to. Just curious as I'll be ordering mine at end of season

[nitrodude24]

I never really fill the starboard to 1/2 full but the door bows a little on the port side. I think again the higher deck on the 13 up LSV reduces the pressure on the dividers. I didnt remove the carpet covered front spacer at the top on both sides of my lockers gives you a little more room. You just have to watch the edges of the top deck. I ran a sanding drum along the edges to get rid of the sharp edge. The 1/2 dividers bowed with the factory ballast. I've installed the flow havent tested it yet. I hope to not have to run quite as much weight.

[greenmachine13]

Does anyone have the flow surf on the lSV's? just ordered a set after seeing how well they worked on the mondo.

[wolfeman131]

I don't own a LSV, but have surfed a 2015 with the FLOW and it was a great enhancement, IMO. Let the boat ride more level, lengthened and cleaned up the wave. We weren't focused on the side-to-side switching, so really didn't pay any attention to that.