Hey everyone. Been a while since i was on the forums.

06 Möbius LSV

Shaft was leaking bad when I came in yesterday and I didn't notice. It started to rain 4 hours later so I went to cover boat. There was about 4-6 inches of water in hull. Hit the bildge switch and nothing. No light. Hit the reset light and light came on but no bildge.

Used the pump for my ballast bags to drain and tightened the shaft. Stopped the water for now.

But the bildge won't come on.

Is there another fuse beside the resetable one at switch?

If I need to replace the bildge, how do I remove it? How do I disconnect it from the hull?