Results 1 to 10 of 16
Thread: HELP Transmission...
Threaded View
-
07-04-2014, 11:29 PM #1
HELP Transmission...
So I get back from the Texas Jam, boat went straight to the stall. I pull it out today after work, we all load up, back the boat in the water, I put it in reverse... NOTHING. Going Nowhere!
I'm freaking out. Prop is good. Check levels. Really low tranny fluid. Run to the gas station close by and buy the only thing they have, plain ole Pennzoil ATF fluid. Fill up. Doesn't work. Upon further inspection, find three bolts and three nuts in the hull and realized the shaft had separated after the bolts fell out... Put those three bolts back in, tightened em down, and on our way we went. Mainly tied up today but tomorrow we will be doing more driving/surfing...
So two questions..
Do I need to drain that plain tranny oil out and get the dextron III stuff, immediately??? (Id like to spend tomorrow on the water if I can and replace the fluid on Sunday...)
Also, are those three bolts all I need or am I missing more?
Thanks,
Taylor2004 Outback Blue on White *Sold
2008 LSV Blue on White
EXILED with 6 SX65-M in cabin & 2 XM9s rockin the tower
2 Kicker ZX700.5 Amps powering the entire boat with 2 10" Subs under the dash
Krypt KMA4200 EQ under driver's side dash to control all the madness
Z5 Cargo Rack annnnnnnd She's NEKKKKED....
I'm no expert, I just read up on the Moomba Forum...