Results 11 to 14 of 14
Thread: Need Screwing Advice
-
06-25-2014, 12:32 AM #11
Need Screwing Advice
X2. Did this last year. My previous boat had rotten bunks that had to be replaced. These were still sound, just the holes were rotted out a little. I tried going bigger but without being able to go longer I had little to no luck. A slight move worked great.
So where do all those missing lag screws end up???-Jake
-
06-25-2014, 05:40 AM #12Banned
- Join Date
- May 2014
- Location
- Clermont, Fl
- Posts
- 586
I hate those lag screws.
When I recarpet my bunks, I'm gonna use stainless hex head bolts, flat & lock washers and nuts and counter sink the bolt head under the carpet.
-
06-25-2014, 10:37 AM #13
Need Screwing Advice
David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
06-25-2014, 11:43 AM #14
I have some carpet starting to pull off to one side one of my rear bunks. Might just redo the whole thing all at once one of these days. I'd use the method above too. Remember to use at least galvanized replacement bolts if not stainless.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!