Trailer axle bearing / seal leaking?
Originally Posted by
slipperyrockTKE300
sometimes I think we all see the wrong pdf instructions for our trailer hubs. I came across two that are very similar.
Ours are not pressurized - other than the lube being forced into the bearings and trapped until a slight oozing appears on the front bearing, and then the cap squeezes the grease back in.
I'm not so sure that the spring loaded cap will allow for a zerk fitting to work. Not saying it won't, but after seeing how it operates, not sure it will. There is a mechanism inside the cap that spins and it may keep grease from getting to the bearings.
The zirk fitting - (a new one comes with the rebuild kit) is located under the cap
Can you show a picture of where this zerk fitting is?
Sent from my iPhone
David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD