Results 1 to 4 of 4
-
06-23-2014, 08:21 AM #1Junior Member
- Join Date
- Jul 2013
- Posts
- 1
Mojo Gravity III Ballast Pumps mounting
Good Morning- I recently removed the panel covering the pumps for the ballast system and I see they are mounted to a board. This board is not mounted to anything and is just being held in place by the fill/drain lines basically. I see the L brackets but do not see where this mounts as I cannot find any existing holes. Does anyone have a photo of this set up they can post for me. Thank you in advance
-
06-23-2014, 10:31 AM #2
Mojo Gravity III Ballast Pumps mounting
I wondered about this as well when I saw mine so I contacted SC. This is intentional, the l brackets are not utilized. I've thought about putting some screws in it to help avoid harness and line rubs bit I think it's held pretty well by the lines and the cover panel.
Sent from my iPhone using Tapatalk2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost
-
06-23-2014, 01:12 PM #3
Same here on my 2014 LSV. Board was just sitting there with brackets not attached to anything. Didn't matter to me since I was moving the pumps anyway.
Joe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
06-23-2014, 02:25 PM #4
same on mine, no biggy really, its not going any where. mines sitting in the garage someplace--pumps moved.
Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart