Results 31 to 40 of 46
-
08-19-2014, 08:15 PM #31
-
08-19-2014, 08:52 PM #32
Cockpit and tonneau cover leaking...
I posted these in another thread as well... This is how I installed in my mojo...
Sent from my iPhone using Tapatalk2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost
-
08-19-2014, 08:56 PM #33
-
08-20-2014, 03:00 PM #34
How/what did you connect the strap at the front and is the rear pole sitting on the floor?
2014 MOJO 345 Surf - Sold
2005 Mobius LSV, carb - Sold
-
08-20-2014, 03:16 PM #35
I have my front straps around the grab bars (which it looks like uniwarking does as well). I believe he has his rear pole sitting on the bench between the cushions, but I have it sitting on the floor in my OBV.
Mike
2013 Outback V
- ballast: 900# rears / 400# center / 650# IBS
- audio: Exile SXT9Q x 2 towers / Kicker KM65 x 6 cabins / Xi 12 sub / Javelin & XM15.4 amps / ZLD
- FAE
- DIY suckgate
2003 SeaRay 182 -- gone but not forgotten...
-
08-20-2014, 03:45 PM #36
Thanks, I'll give that a try. I've been struggling with the factory cover. I think this will help a lot.
2014 MOJO 345 Surf - Sold
2005 Mobius LSV, carb - Sold
-
08-20-2014, 04:36 PM #37
Took me a while to figure out as well... I started with just the poles under the cover but that didn't work out very well.
2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost
-
08-20-2014, 05:22 PM #38
I do mine differently as i used the grab bars by the cupholders for the back pole i am going to change it up.
Update---- just talked with my dealer and he said the back straps should go to the pop up cleats at the back2014 Mondo with da flow!!! Exile towers, stock everything else.... for now!
-
09-15-2014, 08:41 PM #39
-
09-16-2014, 07:32 AM #40