Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Babes cleaning

  1. #11
    Join Date
    Jun 2008
    Tooele UT....


    I saw several mold-specific products in the boating aisle at fleet farm the other day. lots of stuff out there, but I'm with jm in that simple green is typically the first go-to for issues...

    wonder if you could put a towel down between them to keep them from touching. would mold then form on the towel vs boat?
    I know there are small 12v fans that some keep on the floor when stored if you have access to a battery charger to keep the batteries fresh while sitting.
    '06 Supra Launch 20SSV-gone but never forgotten

  2. #12
    Join Date
    Mar 2003
    s.e. washington state


    I've made a pvc pipe frame for my previous boat that kept the cover off the boat. The pipe bends real well.
    1998 Mobius
    310 HP PCM

  3. #13
    Join Date
    May 2014
    Clermont, Fl


    PVC frame - I did the same thing with the Outback. worked real well.

    Not so much with the OBV. That sundeck is a lot bigger - more surface area.

  4. #14
    Join Date
    Mar 2010
    Irondequoit Bay, NY


    I have used the 3M mildew remover and it worked after reading and it saying that to use a brush to work it in I'll try it again. Also I have the give props to joe, babes works well and I love the smell..just wish they would give our dealer a break so I could buy from them..I'll also have to try a pvc frame for the cover..I use the 3/4 inch lbs for gopro mounts and I might try to make a flag pole since I have extra haha
    2004 Outback Blue/white w/5.7 indmar 350, Direct Drive
    Rockford fasgate cabins
    Rockford fasgate 500w amp (cabin) and a kenwood HU (kmr700u)
    Exile XM7's
    Exile Harpoon
    Exile ZLD
    Polk 10in sub (2)
    Polk P330 amp (subs)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts