Results 1 to 5 of 5
Thread: IBS ballast instal kit
-
04-14-2014, 07:35 PM #1
IBS ballast instal kit
Wake makers offers a install kit for the IBS bag(Moomba Piggyback Front Factory Ballast Upgrade (2013-2014)) has anyone tried this and if so was it total plug and play
2013 Moomba LSV2013 LSV
2006 outback DD sold
2004 Stingray 180LX sold
David
-
05-17-2014, 08:06 AM #2
Just installed this on my Mondo yesterday. I am actually cruising the forum looking for a few instructions for adding a check valve. The kit didn't come with one and from what I have been reading it helps with draining the IBS completely flat. It works ok but the IBS had a little water left in it after it went through the empty cycle.
The install was pretty straight forward. It was a little tough working in that small compartment under the helm. Because of the small work areas, I ended up cutting the pipe's a couple of times because I didn't want to go too short the first go around.
ibs2.jpgMark
2014 Mondo
2013 Yamaha AR190 - Gone...
-
05-17-2014, 08:25 AM #3
I just did mine as well, was pretty simple. Getting the fittings on the lines is a bit of a chore but from start to finish it will take you less than 20 minutes.
I've not had the chance to try mine out yet but the guys at wakemakers said a check valve isn't needed. It would help empty the bag some but it would also slow down the emptying a great deal.
The plug and play kits for the rear also work great, I installed the 900's in my Mojo.2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost
-
05-17-2014, 08:48 AM #4Mark
2014 Mondo
2013 Yamaha AR190 - Gone...
-
05-18-2014, 10:25 AM #5
IBS ballast instal kit
Have not had mine out to test yet Wakemakers said they are really about the same as the 1100's in that space so I'm sure they'll flex the walls and they'll need some beefing up.
Sent from my iPhone using Tapatalk2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost