Page 3 of 4 FirstFirst 1234 LastLast
Results 21 to 30 of 39
  1. #21
    Join Date
    May 2009
    Location
    North End Lake Lanier GA
    Posts
    8,155

    Default

    Quote Originally Posted by Mrd8ker View Post
    Wires climb the tower from the portside only.

    Mike - ramp fixed? Are talking about Hagg? Had to put in at far ramp last Sunday (Ramp C?) because the closest was closed.

    We are probably going to go out but aren't sure where yet. Considering braving the Willy.

    sent from my S4 using Tapatalk
    Yea Ramp A was damaged, the anchors holding the ramp steady broke.

    Ramp C is the one with 2 docks, I personally don't like that one.

    Your a braver man than me at the Willy.
    Also don't forget, no wake enhancing devices are allowed in the Newburg area.
    Ohh Yea the River if about 7-10 degrees colder then Hagg.
    Malo <--- Means--Evil or Mean One. This explains a lot.
    2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
    [COLOR="#696969"]

  2. #22
    Join Date
    Jul 2010
    Location
    Vicksburg, MI
    Posts
    1,131

    Default

    Quote Originally Posted by Mrd8ker View Post
    Wires climb the tower from the portside only.
    How did they get the wires into the rear cross bar? I didn't think there was a hole drilled into it from the factory.
    Joe

    2014 LSV
    2010 Outback V - Sold
    1993 Echelon

  3. #23
    Join Date
    Jan 2014
    Location
    Newberg, OR
    Posts
    129

    Default

    I don't see that a hole was drilled. It appears there was access already. There are two holes on the bottom of the rear cross member that have grommets installed (approx 1" from down tube on both sides). Didn't look that close before I sent it for audio to see if it came from the factory that way. If you need more pictures, let me know.

    sent from my S4 using Tapatalk
    2014 Moomba Mondo - Exile Tower/Sub/ZLD/EXBT4/Amps (2x), Hertz Cabin - Evolution Cover - 650 IBS, 900s Rear, Center Hard Tank, Flow
    1969 Bayliner Tahiti - 120 HP Force Outboard - Gone but not forgotten

  4. #24
    Join Date
    Aug 2013
    Location
    DFW
    Posts
    857

    Default The audio is in!

    After literally just finishing my install on my 4 towers on my regular OZ tower, I could see where it would be possible to run the wire up the port side, through the front cross bar, then cross back through the rear crossbar from the starboard side. I thought about it, but couldn't get my fish tape under (or over) the bimini sleeves on the front if the tower. Instead I ran a line up both sides of the tower. The port side only feeds 1 speaker and the starboard run feeds 3. I'm not sure why they have access in the starboard side of that rear crossbar only.
    Matt
    2021 Mojo
    2016 Mojo (sold)
    2012 LSV (sold)

  5. #25
    Join Date
    Jul 2010
    Location
    Vicksburg, MI
    Posts
    1,131

    Default

    I wonder if they went up the front tube and over to the starboard side on Mrd8ker's boat. With the larger tubing on the OZ HD, I think it would be a lot easier to get the wires past the bimini sleeves.
    Joe

    2014 LSV
    2010 Outback V - Sold
    1993 Echelon

  6. #26
    Join Date
    Dec 2012
    Location
    Trois-Rivieres, Quebec
    Posts
    196

    Default

    Quote Originally Posted by Mrd8ker View Post
    Here you go. Sorry for the delay guys.

    Carpeted partition above footrest
    Attachment 19614

    Partition removed
    Attachment 19615

    Lefthand bracket
    Attachment 19617

    Rear of sub (taken from storage locker under portside bow cushion facing stern)
    Attachment 19616
    Thanks fur the pic.... So the sub is facing down? It won't show from the carpet panel??
    Sampp

    2014 Mondo

    Could be worst
    From nice Québec..

  7. #27
    Join Date
    Jan 2014
    Location
    Newberg, OR
    Posts
    129

    Default

    Yes, sub is facing down. Carpet panel fully covers the sub.

    sent from my S4 using Tapatalk
    2014 Moomba Mondo - Exile Tower/Sub/ZLD/EXBT4/Amps (2x), Hertz Cabin - Evolution Cover - 650 IBS, 900s Rear, Center Hard Tank, Flow
    1969 Bayliner Tahiti - 120 HP Force Outboard - Gone but not forgotten

  8. #28
    Join Date
    Dec 2012
    Location
    Trois-Rivieres, Quebec
    Posts
    196

    Default

    And ok, one more question....is there a passage from starboard to port side for the wires?
    Sampp

    2014 Mondo

    Could be worst
    From nice Québec..

  9. #29
    Join Date
    Aug 2013
    Location
    DFW
    Posts
    857

    Default The audio is in!

    Yes. If you look in your center locker, you will see it. You will have to put your head in the locker to see it. The main bus wires travel through it.
    Matt
    2021 Mojo
    2016 Mojo (sold)
    2012 LSV (sold)

  10. #30
    Join Date
    Dec 2012
    Location
    Trois-Rivieres, Quebec
    Posts
    196

    Default

    Quote Originally Posted by Woody929 View Post
    Yes. If you look in your center locker, you will see it. You will have to put your head in the locker to see it. The main bus wires travel through it.
    Ok thanks.
    Sampp

    2014 Mondo

    Could be worst
    From nice Québec..

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •