Results 11 to 16 of 16
Thread: Putting Tower Speakers on a Mojo
-
04-11-2014, 09:13 PM #11
I sure wished they would start pre wiring from the factory as well. Im running 4 rev8 and it was a pita
Chris H.
2012 Mojo
Wake Life
WS420sq,4 Rev8's,JL Amps,2-TypeR 12's,6-Interior Kicker, Green/White LED
-
04-11-2014, 10:30 PM #12
Putting Tower Speakers on a Mojo
I'm doing the 4 XM9s tomorrow. Finishing my amp board now... Waiting for carpet glue to dry
Matt
2021 Mojo
2016 Mojo (sold)
2012 LSV (sold)
-
04-12-2014, 12:10 AM #13
Putting Tower Speakers on a Mojo
Awesome get plenty of pics!
-Jake
-
04-13-2014, 11:53 AM #14
Putting Tower Speakers on a Mojo
It took me a while to figure it out after I drilled my holes yesterday, but I found a fairly easy way to run the wire in the tubes. I used my fish tape to run a real heavy test fishing line from the bottom to the top. When the tape was past my drilled hole, I would grab the fishing line with a hook from this kit (http://www.lowes.com/ProductDisplay?productId=50158911 I had just happened to buy the kit earlier in the day because I needed an awl). I would then cut the line and tie it off. Next, I would repeat jumping from hole to hole. Once all the fishing line was run, I pulled the wire.
You can see here where my wires all exited the tube. I used the larger pre drilled hole on the right to connect 3 out of the 4 speakers to the main run.
Matt
2021 Mojo
2016 Mojo (sold)
2012 LSV (sold)
-
04-13-2014, 02:13 PM #15
What is with the group of wires just above the driver's seat?
Joe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
04-13-2014, 03:37 PM #16
Putting Tower Speakers on a Mojo
I used the larger hole where the grommet is to tie them all together.
The cable is a 4 conductor, so in that bunch, there are 4 leads.
1 is the main feed, 2 are for the right speakers, and the other is for the left speaker on the rear crossbar. The far left lead you see goes down the tower, and will tie in at the amp.Matt
2021 Mojo
2016 Mojo (sold)
2012 LSV (sold)