Results 1 to 10 of 21
Thread: OZ HD tower on 2014 Mondo
-
03-30-2014, 11:16 AM #1
OZ HD tower on 2014 Mondo
Anyone has seen the thread below?
https://forum.moomba.com/showthread....n-lowered-down
Does anyone has tried that on a Mondo? Is it the same? I will have to adjust the cable for sure if I want to fit the boat in my garage...Sampp
2014 Mondo
Could be worst
From nice Québec..
-
03-31-2014, 05:07 PM #2Senior Member
- Join Date
- Aug 2008
- Location
- Hilliard, Ohio
- Posts
- 794
Sampp, Just had some time to check out my Mondo on the trailer.
From the factory the screw looks to have adjustment of about an 1" or so.
Currently my tower is at 84.5" but the jack is high. I should have more time this week to adjust and get her under the 83" I hope. The problem I have is the fixed racks on the upper points will have to come off, not sure if I will order a second set of swivel or what at this point.
-
03-31-2014, 08:15 PM #3
I think mine is up to 7'3" with the wake tow on top of the tower. I didn't have à l'éveil when I to ok the measure.
I'm thinking about butine some smaller wheel and tire and swap just before backing the boat in the garage.
My new boat is still at the dealer, so not that easy to make some other measures...Sampp
2014 Mondo
Could be worst
From nice Québec..
-
04-01-2014, 04:24 PM #4Senior Member
- Join Date
- Aug 2008
- Location
- Hilliard, Ohio
- Posts
- 794
I did not look at the wake tow point, will have to look at that too.
-
04-11-2014, 05:24 PM #5Senior Member
- Join Date
- Aug 2008
- Location
- Hilliard, Ohio
- Posts
- 794
It won't go in the garage due to the tower tow point. Might look at dropping the trailer closer to the tires. Think there was a how to on it.
-
04-14-2014, 08:47 AM #6
Should be the same, you can lower quite a bite. I am pretty sure it is only one size OZ tower ('14) that is used for the all boats. That being said you will have different lowering levels between a Mojo and a Mondo since the cabin area is a little smaller on the Mondo.
What axles do you have on the trailer, torsion or springs?
-
04-14-2014, 09:01 AM #7
-
04-14-2014, 01:10 PM #8
OZ HD tower on 2014 Mondo
If you physically measure the OD of the towers, what are the measurements of the OZ and OZ HD? I'm getting 1.895" with calipers on my tower.
Sent from my iPhone using Tapatalk2022 Moomba Mojo
2013 Moomba Mojo 2.5 (sold)
Tow - 2019 Ford F150 Ecoboost
-
04-14-2014, 01:44 PM #9
-
04-14-2014, 01:48 PM #10
I think standard Oz is 1 7/8"