Results 1 to 10 of 12
Hybrid View
-
07-08-2013, 07:05 AM #1Member
- Join Date
- Mar 2012
- Location
- Ogdensburgh,NY
- Posts
- 43
pictures of reinforced locker walls please
Ok, I have searched the forums and I understand the importance of reinforcing the locker walls for the 1100lb bags....however i just can't seem to upload the pictures.....I am a visual guy can someone send some pictures for me of the finished product.....
thx2013 not a Moomba
-
07-08-2013, 07:36 AM #2Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
-
07-08-2013, 09:06 AM #3
I did mine like daze, attached to the door, but instead of doing 4 vertical brackets , I did two "vee" shaped to cover the door with less aluminum.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
07-08-2013, 09:39 AM #4
-
07-09-2013, 11:11 PM #5Member
- Join Date
- Mar 2012
- Location
- Ogdensburgh,NY
- Posts
- 43
I am not very mechanically inclined and it freaks me out drilling holes anywhere near the bottom of the boat...so when i put the bottom bracket on i use 1 inch screws and I will have no problem? do i need to put the bottom bracket o or can i just reinforce wall?
thx for pics its greatly appreciated!2013 not a Moomba
-
07-09-2013, 11:43 PM #6
I ended up removing that hinge in the middle and using a L bracket on the motor side so it doesnt push in.
Its hard enough to work in the motor well so i elected to mount something on the doors and not the aluminum motor frame
-
07-10-2013, 10:22 AM #7
pictures of reinforced locker walls please
2004 Outback Blue on White *Sold
2008 LSV Blue on White
EXILED with 6 SX65-M in cabin & 2 XM9s rockin the tower
2 Kicker ZX700.5 Amps powering the entire boat with 2 10" Subs under the dash
Krypt KMA4200 EQ under driver's side dash to control all the madness
Z5 Cargo Rack annnnnnnd She's NEKKKKED....
I'm no expert, I just read up on the Moomba Forum...
-
07-10-2013, 06:37 PM #8
pictures of reinforced locker walls please
Haven't done mine yet and quite frankly I haven't seen the need to yet either...
SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
-
07-11-2013, 04:48 PM #9
Based on E4NASH's similar comment on a previous thread, I chose to try my 1100 bag without reinforcement. I also have not yet seen a need for the reinforcement. However, I did remove the hydraulic lift and bracket on the 1100 side (I have 650 in other side) and I fill that sucker up all the way, the lid is lifted up a couple inches when I'm done filling sometimes lol!
If you haven't lengthened your fill hose yet (if you have to on a 2011, mine's a 2006), I used stuff from Lowe's to extend my fill hose on both sides; it was $11 for materials and took about 5 minutes to do.Boats previously owned - 2000 Supra Launch, 2003 Outback, 2006 Mobius LSV
-
07-11-2013, 05:49 AM #10
pictures of reinforced locker walls please
2004 Outback Blue on White *Sold
2008 LSV Blue on White
EXILED with 6 SX65-M in cabin & 2 XM9s rockin the tower
2 Kicker ZX700.5 Amps powering the entire boat with 2 10" Subs under the dash
Krypt KMA4200 EQ under driver's side dash to control all the madness
Z5 Cargo Rack annnnnnnd She's NEKKKKED....
I'm no expert, I just read up on the Moomba Forum...