Results 1 to 10 of 15
Thread: Ballast right switch
Hybrid View
-
06-09-2013, 10:19 PM #1Member
- Join Date
- Mar 2009
- Posts
- 46
Ballast right switch
2008 möbius LSV
Right rear ballast not working.
I think it is the switch.
Are they easy to change?
-
06-09-2013, 10:21 PM #2
Ballast right switch
Yes, easy to swap out, but what makes you think it's the switch?
-
06-09-2013, 11:06 PM #3Member
- Join Date
- Mar 2009
- Posts
- 46
Well Drew when I took the rear cover off, which is underneath the rears seat, there are 3 pumps with Selinoid valves on top of them, one for the right fatsack fill, one for the center fatsack fill and one for the left fat sack fill.
Since the right was not working I unplugged the center wiring (which has a plug in to the center selinoid) and plugged this in to the right silinoid and when I flipped the center switch to fill, the right side worked. So I know it is not the pumps.
What else could it be?
Is there any sort of fuse that I should check? If so where might this fuse be?Last edited by kerryoneal; 06-09-2013 at 11:15 PM.
-
06-10-2013, 08:47 AM #4
So you used the center switch to control the right pump/solenoid. Did you use the right switch to control the known ro work center pump/solenoid? The switch may not have its B+, therefore it will not work. Do the lights come on in either the fill or drain position? Does the drain pump work?
A 12V test light or volt meter will tell you if the switch has its B+ and is working.
-
06-10-2013, 10:36 AM #5Member
- Join Date
- Mar 2009
- Posts
- 46
MLA...Correct, I used the center switch to control the right pump. When I connected the right switch to the center it did not work. Only the right side is not working. The red light does come on when i press the switch to fill or empty. However, neither the fill or drain position works.
-
06-10-2013, 12:37 PM #6
-
06-09-2013, 11:23 PM #7
Ballast right switch
That's a good start. Those style pumps with the irrigation valves can get gummed up, etc and sometimes it's the pump or the solenoid but I haven't heard of many switches burning out. Have you tried it by jumping/ bypassing the switch under the helm?
-
06-09-2013, 11:28 PM #8Member
- Join Date
- Mar 2009
- Posts
- 46
No. How wyd I go about doing that?
-
06-09-2013, 11:36 PM #9
-
06-09-2013, 11:53 PM #10Member
- Join Date
- Mar 2009
- Posts
- 46
I am not understanding what I should do?