Results 1 to 7 of 7
Thread: Tower parts
-
06-03-2013, 09:03 AM #1
Tower parts
I have a 09 lsv, I need the rubber gaskets that go in between where the tower bolts to the boat. Can someone point me to where I can buy them. Thanks
Sent from my SCH-I545 using Tapatalk 4 Beta2009 moomba Mobius lsv
-
06-03-2013, 10:50 AM #2
Never heard of you being able to buy them, even the dealer just cuts them to order.
You best bet is goto Agenda Surf
http://agendasurf.com/dir/products/b...-set-grey.html
You can also get Gator grip at Home Depot, i even used a rubber car floor mat for my 08 LSV,
Remove the old traction pad, use it as a template and cut your self a new one and install it.Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
[COLOR="#696969"]
-
06-03-2013, 10:54 AM #3
Tower parts
I did this same thing last week. I just used the old (factory) swim step pad that was left over from my seadek install a few years ago. It worked great! As mike says, use the old one as a template.
'08 Mobius LSV- SOLD!
2017 Mojo Pro
-
06-03-2013, 11:00 AM #4
I ordered mine from Atlanta Marine. They were adhesive on one side but still didn't stay in place very well. I will make my own next time and probably epoxy them to the tower base.
-
06-03-2013, 11:00 AM #5
I bought some for my dealer for like 15 bucks. Lasted about a season and now there are all squashed out haha.
David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
06-03-2013, 11:05 AM #6
-
06-03-2013, 01:50 PM #7
Re: Tower parts
Thanks for the replies. I will probly do the same, just cut up some old floor mats or something like that.
Sent from my SCH-I545 using Tapatalk 4 Beta2009 moomba Mobius lsv