Results 1 to 7 of 7
Thread: I have a leak....
-
05-29-2013, 10:11 AM #1Member
- Join Date
- Apr 2012
- Location
- Indiana
- Posts
- 40
I have a leak....
photo.jpg
I know very little about motors but I'm having a leak from the underside of that piece on the left side. Any ideas how I should approach this?05 Moomba LSV
-
05-29-2013, 11:18 AM #2
First need to know what it is lol. Is that the Exhaust from the muffler to the stern where it goes out to the water?
Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
[COLOR="#696969"]
-
05-29-2013, 11:19 AM #3
Can you open your picture in "Paint" and draw an arrow showing exactly where the leak is coming from? Then save it and re-post it. Might help.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
05-29-2013, 04:10 PM #4Member
- Join Date
- Apr 2012
- Location
- Indiana
- Posts
- 40
It's on the underside of the exhaust. See the red arrow.
05 Moomba LSV
-
05-29-2013, 05:27 PM #5
OK if its the muffler, then just take a bolt and screw it in the hole, honestly, it wont hurt anything because on the other side of the muffler is a screw for draining water when winterizing.
If its on the outbound tune from the muffler then tape it with waterproof tape, its a low temperature system and you only need to stop the water so its not filling the bilge, but its after the engine so its no real panic situationMalo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
[COLOR="#696969"]
-
05-30-2013, 09:57 AM #6
-
05-30-2013, 04:44 PM #7
If its at the hull then you need to check you screws on the outside of the hull. you may be able to tighten them if they are loose or clean and reseal the exhaust thru hull with silicone.
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug