I have installed a set a gauges/switches from a newer boat (around an '03 or so I believe) into my '98 Outback and I'm having an issue where the engine will start but will not stay running unless I hold the key in the "start" position. I have power to the ignition post on the key, no power to the + side of coil when on "run". All the gauges stay powered though.

I'm thinking it may be from the kill switch wiring as my '98 didn't have one and the newer boats did. Can someone please take a look at the wires off of their kill switch and tell me what colors they are? I'm not even sure if it ran into the switch wiring or not. Any insight would be helpful.

Thanks,

Eric