Results 1 to 10 of 17
Thread: Prop shaft coupler bolt????
05-04-2013, 03:58 AM #1Senior Member
- Join Date
- Jun 2008
Prop shaft coupler bolt????
I spent a good couple hours trying to get my prop shaft coupler bolt out and could not get it to loosen?
I was cranking on it both directions and al it was doing was torquing the shaft....When I pushed the shaft back up to put a couple bolts in to hold it now the coupler and tranny plate are about 1/4 inch offset....Did I bend my prop shaft trying to get the nut off?
I backed out the set screw but could not get the bolt to loosen....Is it a reverse rotation nut? Think its a bad idea to hit it with an air ratchet?
I'm replacing my dripless packing seal that was a steady stream. Think it could have gotten hot enough to "stick" the nut and coupler/shaft together.......HELP
Hillbilly07 LSV usually DUMPED