Results 1 to 10 of 10

Hybrid View

  1. #1
    Join Date
    Oct 2012
    Location
    Wisconsin
    Posts
    11

    Default Boat Lift Setup for 2012LSV

    Does anyone have any specs for proper placement of Bunks for a shoremaster vertical lift?

    I will try to setup based of the trailer, but usually requires some fine tuning in the water when the boat arrives.
    2012 Moomba LSV (Upgraded from Four Winns H210 270hp)

  2. #2
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    7,692

    Default

    When I setup my Great Lakes lift. I measured the height (to clear the skegs) and width of the trailer bunks, I narrowed them slightly toward the bow to create an automatice stop on the boat so the strut and prop would not pull through and hit the cross bar of the lift..

    this thread may help.
    https://forum.moomba.com/showthread....ght=Lift+bunks



    congrats on the new 12 Lsv and welcome to the forum!
    Last edited by jmvotto; 02-24-2013 at 10:57 PM.
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

  3. #3
    Join Date
    Jul 2002
    Location
    London Ontario Canada
    Posts
    2,259

    Default

    You want to make sure the rear support does not hit the prop shaft when lifting the boat out of the water.
    09 21v LAUNCH

    99 Outback LS. Sold


    run your engine after you change your oil
    68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
    Doug

  4. #4
    Join Date
    Jan 2013
    Location
    North Dakota
    Posts
    164

    Default

    If you can swing it, put a 110V winch with remote on your lift too. It makes getting in and out sooo much easier. As soon as I float off the lift I hit the remote for a few seconds to raise the lift just enough so when I come back in I can idle in under power and the bunks stop me.

    I wouldn't trade my 110V winch with remote for all the Crown Royal in the tri-state area!
    2013 Mobius LSV
    2004 Centurion T5

  5. #5
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    7,692

    Default

    I second the 110v winch, I would not have it any other way.
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

  6. #6
    Join Date
    May 2008
    Location
    Minneapolis
    Posts
    507

    Default

    I have the same lift with a 12v powered motor and a big solar charger since there isnt power anywhere its awesome hit the remote and she goes down... when I set up my lift I measured the bunks on the trailer and made some minor adjustments to the lift I have the front bow stop and recommend one for you as well so there is no need to worry about driving over the lift
    2007 Outback V

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •