Results 1 to 7 of 7
Thread: Tower lights
02-19-2013, 02:44 AM #1
I have a feeling ill get beat up on here again because I want to spend my money ( I have a few words to say but ill bite my lip and keep it in) but I want to take off an old ugly light bar I have on top of my tower..anyone know where to get a nice light from?2004 Outback Blue/white w/5.7 indmar 350, Direct Drive
Rockford fasgate cabins
Rockford fasgate 500w amp (cabin) and a kenwood HU (kmr700u)
Polk 10in sub (2)
Polk P330 amp (subs)
02-19-2013, 04:52 AM #2
Monster makes a sweet one
As well as Roswell.
http://www.wholesalemarine.com/p/AWT...+5+lights.htmlMalo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
02-19-2013, 09:52 AM #32016 Moomba Mojo
2006 Supra 24SSV - Traded
02-19-2013, 10:13 AM #4
Moto, welcome back.
Bakesonline has some as well as the above list
http://www.bakesonline.com/searchres...CategoryID=519A Day at the Lake...Priceless
A Day in Powder...Endless
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
02-19-2013, 10:24 AM #5
I put one of those little dome anchor lights on my tower after I broke the other one about 5 times. The thing was more epoxy than plastic by the end. I haven't bumped the new one at all and only used it one time (no night boating in FL unless it's gator season).My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)
P5 Danielo Diamond 58"
02-19-2013, 01:20 PM #6
I know you stated that you already had tower speakers, but this is what I went with from Aerial. Sorry for the low quality pic, it was all I had.
Assuming that you have the Rad-a-Cage tower like mine, you will have an issue with the Areial clamps since the rubber inserts only go as small as 1 3/4", and our tubing is 1 5/8". I took a length of black 1 1/2" ABS plastic pipe and cut it to the width of the clamps and then cut it length wise in half. The two pieces snap over the tower making the diameter larger. The black ABS blends in nicely with the black rubber inserts making them look like one piece. By the way, I ended up moving the speaker/light bar to the forward tube. They looked and fit much better.Joe
2010 Outback V - Sold