Results 1 to 3 of 3
Thread: Transmission Screen Cover Wrench
-
09-21-2012, 09:10 PM #1
Transmission Screen Cover Wrench
Since it seems like summer is over up here in Michigan, I decided to change all the oils in my boat today, and attack the transmission screen for the first time. I followed DOCDRS Transmission and Vdrive post, but I found a minor issue with it. The two bolts that hold the transmission screen cover plate are metric, and therefore require a 13mm wrench, not a 1/2 inch wrench. In some cases a 1/2 inch wrench may work, bot not in all. I do not know how long the transmission has been using metric hardware, but it is definately metric in the 2010's. I was going to add this to DOCDRS post, but it is closed. Hope this helps others that have tried.
Joe
2014 LSV
2010 Outback V - Sold
1993 Echelon
-
09-21-2012, 09:48 PM #2
Very thoughtful of you to post on this. How did it all work out for you?
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
09-22-2012, 10:59 AM #3
Thanks and the post has been updated
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug