Results 31 to 40 of 165
Thread: Exiled...
-
09-11-2012, 10:11 AM #31
All the holes are cut and the wires run, we just had to trim the vinyl out to mount the speaker in the factory location.
2013 Outback V
-
09-11-2012, 10:38 AM #32
-
09-11-2012, 11:12 AM #33
Vinyl cuts are no big deal....BUT, you must correctly terminate the vinyl (beyond the four speaker screws) so that it has no ability to stretch. Otherwise you may have issues later.
David
Earmark Marine
-
09-11-2012, 12:51 PM #34
Helped a buddy do this to his little Blue Water runabout during an install last year. I was cringing when we cut the first hole through the vinyl for the 6.5" near one of the rear seats but it really wasn't that bad at all surprisingly. Was still glad it was HIS boat though for those first few seconds!
So when is this "old enough to know better" supposed to kick in?
2001 MobiusV - Slightly Modified...
-
09-11-2012, 09:28 PM #35
Bow speakers installed;
Xi800.4 on top, Harpoon on bottom;
The start of distribution blocks;
2013 Outback V
-
09-11-2012, 10:53 PM #36
How long are those screws that you used to mount the amp board and the distros?
Sent from my iPhone using TapatalkSOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...
-
09-12-2012, 09:57 AM #37
3/8" or 1/2" I don't recall. The are they are screwed into is super thick.
2013 Outback V
-
09-13-2012, 12:04 AM #38
very nice... Cant wait to get my exile installed
Chris H.
2012 Mojo
Wake Life
WS420sq,4 Rev8's,JL Amps,2-TypeR 12's,6-Interior Kicker, Green/White LED
-
09-13-2012, 12:29 PM #39
I gotta say, that green vinyl is a super cool color. Install is looking good Ian. Will be fun to see that boat on the water rocking loud. That's Chase's boat right?
@Chris; You working with Travis right? If so, that guy cracks me up. He's nuts!~ But does know what he's doing. I never did hear what the final configuration was.
-
09-13-2012, 12:43 PM #40
Do you happen to know the model number on those distribution blocks? I've been looking for a single input to a 4 output.
-2012 Supra Launch 21V
-2008 Mobius LSV