Results 111 to 120 of 165
09-20-2012, 08:28 PM #111Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
09-22-2012, 04:03 PM #112
Test fitting the sub and led ring in/on the enclosure;
2013 Outback V
09-24-2012, 07:53 PM #113
The sub is in the boat!
Unfortunately I forgot to bring the "feet" for the box, zip ties, and long screws, so it's just kind of resting in place until tomorrow. Once it's in place I'll cut out a trim panel and cover it in white vinyl, and tuck/tie the wiring.2013 Outback V
09-24-2012, 09:01 PM #114
You take care of the IBS while that front vent was easily accessible?
09-25-2012, 03:43 PM #115
I forgot to reply to your pm! I'm not certain that we'll add any additional weight to the boat, but I guess anything is possible. The floor and box are super easy to pull out, so if we decide to go that route it shouldn't be too tough. I think the dealer is putting a heater in over winter, so all of this will have to come out anyway.2013 Outback V
09-26-2012, 08:51 AM #116
More progress on the sub - I got the box mounted into the boat last night, and put the grille on the woofer;
I have a bit of clean up to do on the wiring on both sides still, but ran out of daylight;
A few shots of the LEDs in darker conditions; they are really bright;
Last edited by ian ashton; 09-26-2012 at 08:53 AM.2013 Outback V
10-01-2012, 09:15 PM #117
What did you use for the cup holder rings?
Sent from my iPhone newtys droid killer using TapatalkDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
10-02-2012, 09:22 AM #118
Here is a post where I detailed how I made them. I have since gotten an actual router table to take a bit of the danger out of the process, lol.
https://forum.moomba.com/showthread....275#post1742752013 Outback V
10-02-2012, 11:40 AM #119Senior Member
- Join Date
- Jun 2010
- Lake Houston
Where did you buy the actual LED strips from? Your post talks about speaker rings from a guy at the boat show and then the LEDs for the cupholders you mention are "spares you had laying around."2013 LSV
2005 LSV - SOLD
10-02-2012, 01:08 PM #120
I bought 3528 SMD LEDs on eBay. There are about 38372847282 million sellers. I think they are ~$20 for 16'2013 Outback V