Results 11 to 13 of 13
Thread: Battery tray recs? (group29)
07-30-2012, 02:18 PM #11
I was going to get some acrylic material and make my own, but decided the effort really wasn't worth it after just using the 2 plastic strap holders. it held my battery just fine and if you measure/install the plastic pieces correctly, they fit the small indents in the bottom of the battery box and give you a guide to get them set in correctly..
at the end of the day, I decided that with them installed in the passenger cubby out of the way and buried behind towels/purses/etc, those frames were more cosmetic than functional and no one would see them anyway'06 Supra Launch 20SSV-gone but never forgotten
07-30-2012, 02:54 PM #12Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
07-30-2012, 03:21 PM #13
You are on the right track. When I added a second and then a third battery, I just duplicated the factory "frame" using left over King Starboard I had from my walkway project and used little galvanized L brackets from Home Depot. See pics below. The frame on the left is the one I made, the one on the right is the factory one. If you don't have easy access to starboard material, you could just go buy a white cutting board and cut it up as needed. The frame not only keeps the battery from sliding around but it also gives you a way to secure the hold down strap.
2006 Mobius LSV