Results 21 to 25 of 25
Thread: Fat sac glue question?
-
07-27-2013, 10:45 PM #21
Senior Member
- Join Date
- Jan 2008
- Location
- Keuka Lake, NY
- Posts
- 7,692
Nope, mine I had a hard time getting them all the way in. My wrists hurt after a while hen I did my GiV upgrade ith all the fittings.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
07-27-2013, 11:50 PM #22
Junior Member
- Join Date
- Jul 2013
- Location
- Whiteshell, MB
- Posts
- 23
Once i used the pliers it wouldn't tighten, so i left it. Tested about 40% fill and no leak. Hope to get out again tomorrow and fill it full. I bought the cement just in case.
Thanks,2012 Mojo2.5
Ballast:
1100 surf side
400 goofy side
500 under floor
725 IBS
260 bow floor
(The more spotters the better)
Acme1235
-
08-04-2013, 01:06 AM #23
Junior Member
- Join Date
- Jul 2013
- Location
- Whiteshell, MB
- Posts
- 23
Popped off today. I will be using the PVC cement tomorrow. Any concerns about the bilge filling up / components getting wet or flooded?
2012 Mojo2.5
Ballast:
1100 surf side
400 goofy side
500 under floor
725 IBS
260 bow floor
(The more spotters the better)
Acme1235
-
08-04-2013, 07:30 AM #24
Senior Member
- Join Date
- Oct 2010
- Location
- Lake Wylie NC Area
- Posts
- 2,467
if the correct threaded fitting(s) is popping out of a threaded sac port, the threads on one or the other is damaged and glue will likely not hold.
-
08-04-2013, 11:17 AM #25
Junior Member
- Join Date
- Jul 2013
- Location
- Whiteshell, MB
- Posts
- 23
That does concern me.... The threads weren't too bad and i noticed Boonejeepin had the same issue. I know they are boat engines / components but i just worry about water splashing around in there....
2012 Mojo2.5
Ballast:
1100 surf side
400 goofy side
500 under floor
725 IBS
260 bow floor
(The more spotters the better)
Acme1235
Reply With Quote