Results 1 to 10 of 13
Threaded View
-
07-09-2012, 01:12 AM #9
No amp? Is it a Kenwood radio?
Even if you did have to wire it up it's pretty easy. All of the wires from the new HU are labeled. They should be on the old one too. Just disconnect the harness from the stock radio and take the old HU out. Then, disconnect each wire one at a time from the old harness and connect it to the new one. The color scheme should be the same or at least they should be labeled like Front +, Rear -, etc...
If you are running all 6 speakers off of the head unit it may be cutting out at the high volume due to the ohm load. You should look into getting a 4 channel amp to power your inboats and free up your radio...
Sent from my iPhone using TapatalkLast edited by E4NASH; 07-09-2012 at 01:24 AM.
SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...