Results 1 to 10 of 67
Thread: Engine problems from spain
Hybrid View
-
03-11-2012, 06:35 AM #1Junior Member
- Join Date
- May 2008
- Posts
- 23
Engine problems from spain
We need help. We hava changed the full pump. fuel filter,
impeller, spark plugs.Oli levels are perfect.In Spain don´t have service.
We don´t find the problem.
Does anyone have conecctión check and software for the engine??.
Where can i buy the conecction check and software?
Indmar 5.7l 325 hp.The boat has 330 hours.
http://www.youtube.com/watch?v=PrjoPwdsn_8
Thanks.
-
03-11-2012, 12:24 PM #2Junior Member
- Join Date
- Jul 2010
- Posts
- 10
Hi guys, It's my firends boat. We would really apreciate any help on this.
I think we've tried it all by now.
For some reason the boat jumps in the "limp mode" and we can`t find out why.
Any suggestions?
-
03-12-2012, 07:10 AM #3
Hi there.
I get the same problem if i use the cruisecontrol and don´t turn it off after stoping. Check if cruise control is on and turn it off.
-
03-12-2012, 08:24 AM #4
Tell us more about the boat like Year and Model, does it have Moomba Crusie, Perfect Pass? Has it ever run properly for you or is this a new problem?
As superfet noted Moomba Cruise can cause the engine to behave as you descibe if it has been left on after the engine has been turned off.Kraig - 2010 Outback V
-
03-12-2012, 09:04 AM #5
Take a look at your oil level transmission level. That will put your boat into limp mode. Also sheck your impellar. You should be running around 140F. Looks like you were getting higher than that.
PWI as usual...
-
03-12-2012, 11:17 AM #6David
2017 Moomba Mojo Max Surf Edition, 2 Pair Wetsounds Rev10s powered by an SD2, 6 pair Wetsounds XS650M and Wetsounds XS12 powered by SD6 all controlled by a WS420. 2 Lumitec SeaBlaze X2 Spectrum underwater lights
SOLD***2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Javelin, Exile 30.2***SOLD
-
08-21-2012, 05:12 PM #7
-
08-22-2012, 12:27 PM #8Junior Member
- Join Date
- Jul 2010
- Posts
- 10
It's a drive by wire system. It's a 2008. Since this year the tps is attached directly to the throttle handle.
-
08-22-2012, 12:35 PM #9Junior Member
- Join Date
- Jul 2010
- Posts
- 10
We checked the throttle body and it looked clean, we also opened the Etc and it looked perfect. We found the tps and the cable was bend badly, so we straightened it and moved the connections and the boat performed perfectly for the rest of the day.
Next day the boat failed again, so Santi and a car electrician disconected the tps and went through the connections. Everything connects Ok.
Next step would be order a new TPS (I guess...) . I have already contacted Skidim let's see if they have any.
Is there any way to check the TPS?
Thanks!Last edited by Arek; 08-22-2012 at 12:37 PM. Reason: error
-
08-18-2012, 07:36 AM #10
There is a manual throttle body setup for.that intake. Could be an option
2005 mobius lsv 2900lbs ballast2005 mobius lsv