Results 1 to 3 of 3
Thread: ballast tubing size
-
03-06-2003, 07:31 PM #1
ballast tubing size
I'm customizing my ballast in my '01 Mobius. I was wondering if anybody knew the tube diameter for the stock ballast. I think its 1 inch but i'm not sure. Can anybody confirm the for me?
-
03-09-2003, 01:12 AM #2Brian Raymond Guest
Tube size
The hose diameter is 1 inch, the pump outlet is a little bigger, so you may have to heat that end of the hose with a heat gun and put on the pump while warm to have a good fit.Brian Raymond
-
03-12-2003, 07:41 PM #3
inches
For anybody else wanting to know, the "in" tubing is 1" ID, not sure what the OD is. and the "out" is 3/4" OD, probably 1/2" ID. found that out after I bought all one size tubing and nothing match with PVC connectors.
Similar Threads
-
Tubing off tower
By Eric Z in forum General ChatReplies: 10Last Post: 03-25-2008, 01:44 AM -
What size hole for ballast bilge? Dual Battery question also
By sethscott in forum General ChatReplies: 4Last Post: 03-03-2008, 07:12 PM -
Ballast tubing size?
By iaonbb in forum General ChatReplies: 1Last Post: 06-12-2007, 07:53 PM -
Size of stock ballast
By AZ_Calling in forum Wakeboarding | WakeskatingReplies: 1Last Post: 02-19-2006, 09:47 PM -
Size of LSV locker - for ballast
By jchamlee in forum General ChatReplies: 1Last Post: 07-13-2004, 01:01 PM