Results 1 to 10 of 45
08-24-2011, 07:56 PM #1
Bracing your V Drive locker for 1100 Fat Sacs
I received a couple emails on how did i brace my V Drive locker for my 1100 fat sacs.
Parts needed are all from Home Depot
4 3/4 x 48inch x 1/8th long aluminum angle bars. http://www.homedepot.com/h_d1/N-5yc1...atalogId=10053
6 1 inch Lag Stainless Steel Lag bolts
8 Stainless Steel bolts
8 Stainless Steel Machine screws
8 Stainless Steel washers
8 Stainless Steel lock washers
All the above can be substuted for what ever size you want. I persoanly used 24x10 i think it was.
I used 2 48 inch peaces as the bottom rail and used 3 lag bolts to attach that to the floor of the boat.
I then used the 2 other 48inch peases for my upward bracing. Front is apx 22inch high and the rear is apx 21 inch high.
I then bolts the upper braces to the lower angle bracket and then again to the upper cross member in the boat.
Make sure you watch for the locking tabs on the plastic doors. As you can see in my pic i mis measured by 1/2 inch and need to fix that now lol.
Also you will notice the engine actualy doesnt sit centered in the engine bay so pay attention to this when you place your upward braces.
This all cost me about 35 bucks. and 2 hours or 4 beers of time.
Passenger side bracket. Drivers looks the same.
1100 Full on goofy side. You can see where my brace is blocking my panel hinge. That will be fixed ASAP.
I also need to repostion the 1100 bags slightly to allow them to sit a bit more upright.
I will post some video of the surf wave after this next weekend as we are still dialing it back in. I can say this with the 1050 nose ballast i run made a huge improvment wave is now even larger and the pocket is insainely long.Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >