Results 1 to 9 of 9
11-02-2011, 02:23 PM #1
Wakeboard rack to Surf board rack
I took off my racks for winter storage and thought how could I convert my wakeboard rack into a surf board rack, (by removing the centre bracket). So I first went to my local machinist and he suggested try down the street at the granite place they have a water jet cutter, $30 bucks later and a little bite of time re-installing the rubber and there ya have it. Money is a little tight at the end of boating season so this will work for a season or two.
After / Before2004 MOBIUS LSV
11-02-2011, 02:32 PM #2
Nice! I'd be curious what they'd charge to build a set, mimicking the ones you bring in...The years have been kind, it's the weekends that have done the damage.
2001 MobiusV - Slightly Modified...
11-02-2011, 03:00 PM #3
Nice, I plan to do this this winter as well and I am going to try and grove the slot for the rubber where the old finger was.
11-02-2011, 03:21 PM #4
11-02-2011, 05:41 PM #5
our local skiers dealer had some surf tines made a year ago or so. they retailed for $200, so guessing that cost was somewhere around $100 or so. they just replaced the wakeboard tines. looked factory.'06 Supra Launch 20SSV-gone but never forgotten
11-02-2011, 06:36 PM #6
not sure if these would fit the clamps or not, but the diy stuff isnt to bad
Last edited by moombadaze; 11-02-2011 at 06:45 PM.Hey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
11-02-2011, 07:18 PM #7
Does anyone know if having a water jet cut off a tine on a powdercoated rack would distort the paint all over the area of the cut? Or would it come out looking clean like T100's?
11-03-2011, 02:10 AM #8
T100, I have access to a mill and I will either use a slot cutting bit of make a cutter to match the grove.
11-03-2011, 11:27 AM #9
I was thinking about doing the same thing last night. Great idea!