Results 1 to 10 of 12
Thread: Kicker HLCD upgrade install
Threaded View
-
07-20-2011, 11:01 PM #1
Kicker HLCD upgrade install
Had some time and looked at my oem tower set up. As per Loudsubz the bracket is no good fro the horn. So I decided to make my own brackets.
1" inch by 42" of sheet aluminum $5
2-3/8 ss nuts .40 c
1-3/8 bolt .10 c
drill $5
x-acto knife
I first did a test bracket. Then adjusted the back end measurement so there is minimal clearance on the sides. Drilled a hole in the end, tapped aluminum with 3/8" bolt and screwed nut on. I will have the nut spot welded to the bracket tomorrow. I trimmed a notch out of the round plastic bracket with an exacto knife so it would fit flush (very easy)
I only brought one speaker home so I hope this bracket will fit in the can. I will use a dremel and a router bit to trim the round plastic mid bass brackets when I get up north on friday. The brackets took about 10 minutes to bend up in a 3 inch vise.
left is trial center is final right is original
L is final R is original
L is trial R is original
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug