Results 1 to 10 of 21
Thread: aware tsc 55 install help?
-
06-29-2011, 08:08 AM #1
aware tsc 55 install help?
I got a new aeware tsc 55 black for Dads day. It have the backlit wiring for it. so i am going to move the white no back lit tone o the stern and mount the black one at the helm. anyone have experience wiring the lighetd part Pos, neg and switch wire. Is the best place to do it off the navigation switch with jumpers?
http://shopmarineelectronics.com/mar...tes/tsc_55.htmA Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
06-29-2011, 08:59 AM #2
If you could find the wiring for anything on your dash that lights up with lights on, that might be easier.. (Speedo, Tach, etc)
mine is not lighted so i didn't cross that bridge..
may require long wire, but one option is to tie into the Anchor light socket that is on the starboard side of boat.. that is where I tied into for my LED'sBrad
2011 Launch 21V Sold... boatless replaced with a Jeep JKUR
2006 Moomba Mobius LSV sold
2004 Outback sold
-
06-29-2011, 09:38 AM #3
Joe, trace your existing remote wires back to the quick connect under the dash and see if there is a 4th wire that is not hooked up. If so, that should be for the backlight. My quick connect has 4 wires that all go to the remote and the backlight is tied to the Nav/ANC switch that way.
Al
2006 Mobius LSV
-
06-29-2011, 09:53 AM #4Member
- Join Date
- Jul 2010
- Location
- Deep River Ont
- Posts
- 83
Gotta tell ya, when i bought my boat, there was big problems with the kenwood head unit/remote interface. In short, those remotes would not control anything. I was there all day while they tried about 6 different head units and remotes. I wasn't leaving w/o getting what I paid for so they had to go to an electronics store and get a sony head unit and remote. I now have a kenwood " ornament " mounted near the helm, and a VERY nice sony system with lighted remote mounted by the throttle in an even more convenient location....just sayin!!!
2008 xlv gg 340hp
-
06-29-2011, 04:29 PM #5
Brad when did you get LED's
I thought about the anchor light ( which is now a 12v outlet Thanks AL), but i am putting the lighted one in the helm and the white non lighted one on the transom so i only need the remote extensions wire to the back of the boat.
Good thought i will check that first.A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
06-29-2011, 05:11 PM #6
-
06-30-2011, 08:14 AM #7
-
06-30-2011, 08:46 AM #8
-
06-30-2011, 08:59 AM #9
great i will trace them out. or look to a close gauge to jump them from. Just waiting for my Y cable, they sent me two 24ft extensions instead.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
06-30-2011, 09:08 AM #10