Results 1 to 10 of 21
Threaded View
-
06-13-2011, 05:22 PM #1
Upgrading to the Kenwood 107MR Question
I am thinking about upgrading the remote on my dash to the Kenwood 107MR. I was wondering if anyone has managed to fit the larger remote in the factory location on the dash. I know a section would have to be cut out in order for it to fit and it definitely has the potential to not look very good if its not done right. On the newer boats the remote is located on the side which from what I've seen is easier to replace. If I was to put mine on the side I would still have the factory remote on the dash. That there is a deal breaker to me.
I suppose I could have something made the same size as the factory remote to place in that hole if I chose to remove it...hmmm....stainless etched Moomba logo maybe??
Any suggestions?
Also, can two of these remotes be used on the KMR440U?SOLD! 2011 Mobius LSV 325HP EFI
Digital Cruise Pro, Wakeplate, Kenwood KM550U and KCA-RC107MR x2, Kicker ZXM700.5, Kicker 6.5 Cabins, 10'' Kicker CompVT sub, Wetsounds SYN 4, Wetsounds REV10s, Wetsounds WS420Q, Gravity VI Surf Ballast, Acme 537
Board: '12 LF Harley (Monster) 139
Her Board: '11 Ronix Krush 128
Kids Board: '13 Ronix Vision 120
Skate: LF Faction 44
Surf: LF Custom Quad & XXX
Tow Rig:
2011 Toyota Tundra CrewMax TRD Magnetic Grey
3/1 Truxx Lift, and some other stuff...