Results 1 to 10 of 14
Hybrid View
-
05-07-2011, 07:47 PM #1
raw water intake??? for heater install.
Anyone have a pic of the "Y" install on a moomba v drive. I just want to verify where the raw water intake is when i cut that hose and install the "y" fitting.
I assume on the v drive its at the stern of the boat. please correct me if i am wrong. i dont want to make a mistake.
pics would be helpful. the detailed impellar change thread vanished i thinkA Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
05-07-2011, 09:39 PM #2
I can try and get you some pics tomorrow Jm wont be able to get into the engine bay tonight to get anything worth while for you.
Malo <--- Means--Evil or Mean One. This explains a lot.
2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
[COLOR="#696969"]
-
05-08-2011, 04:26 AM #3
Joe, I haven't installed mine yet but cut it into the intake hose between the vdrive and the raw water pump (where the impeller lives).
AlAl
2006 Mobius LSV
-
05-08-2011, 06:29 AM #4
Not sure if this helps you.. it is a bitch to install. I marked where i wanted it then pulled the hose out and installed....
-
05-08-2011, 07:49 AM #5
Just trying to verify where the impeller is, front by the drive or at the very rear of the motor. I was trying to locate it with flash light at 10 pm.
Lsvboombox, thanks. I see that but I want to make sure its the correct one so I can trace it to the impeelar housing.Last edited by jmvotto; 05-08-2011 at 07:53 AM.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
05-08-2011, 08:40 AM #6
If looking at my pic the vdrive is on the right and impellar on left. Its the bottom hose going in the impeller