raw water intake??? for heater install.

[jmvotto]

Anyone have a pic of the "Y" install on a moomba v drive. I just want to verify where the raw water intake is when i cut that hose and install the "y" fitting.


I assume on the v drive its at the stern of the boat. please correct me if i am wrong. i dont want to make a mistake.


pics would be helpful. the detailed impellar change thread vanished i think

[mmandley]

I can try and get you some pics tomorrow Jm wont be able to get into the engine bay tonight to get anything worth while for you.

[cab13367]

Joe, I haven't installed mine yet but cut it into the intake hose between the vdrive and the raw water pump (where the impeller lives).

Al

[lsvboombox]

Not sure if this helps you.. it is a bitch to install. I marked where i wanted it then pulled the hose out and installed....

[jmvotto]

Just trying to verify where the impeller is, front by the drive or at the very rear of the motor. I was trying to locate it with flash light at 10 pm.

Lsvboombox, thanks. I see that but I want to make sure its the correct one so I can trace it to the impeelar housing.

[lsvboombox]

If looking at my pic the vdrive is on the right and impellar on left. Its the bottom hose going in the impeller