Results 1 to 10 of 22
Thread: Suggestions on audio setup?
05-03-2011, 08:44 PM #1
Suggestions on audio setup?
I am looking for a little more advice. I have a Kicker 250.2 amp and a km10 sub that I was going to put in the 2010 boat but because I have the new 2011 comming with the 700.5 amp, I not sure what to do. Has anyone installed 2 10" subs? Is it recommanded or not?
From what I can tell the boat is comming with:
4 cabin Kicker speakers
2 bow Kicker speakers
Kicker 700.5 amp
4 Exile SXT65's
1K Harpoon Amp
In the basement collecting dust.
KM10 Kicker Sub
Kicker 250.2 ampRob Snyder...no not the actor!2011 Celestial Blue/Black Accent Moomba Mobius LSV, 340HP
05-03-2011, 09:02 PM #2
Lat year I did a pair of Kicker KM10's driven by a zxm700.5 in a 1.8 sealed enclosure in a 2009 Bu VLX. It was very impressive. Two 4 ohm KM10 will get you 420W rms form the zxm700.5. Two 10's will move quite a bit of air.
05-03-2011, 11:19 PM #3
05-04-2011, 12:29 AM #4
Hey MLA do you have any pics? Do the sub's have to be in an enclosure or can I leave the factory km10 in the bulkhead at helm and mount the other above it on a right angle or 45 degrees to the factory install so that it is facing down?Rob Snyder...no not the actor!2011 Celestial Blue/Black Accent Moomba Mobius LSV, 340HP
05-04-2011, 10:34 AM #5
I have 2 10" L7's powered off a 700.5 (at least until I put the 1000.1 in) and they sound great. Mine are dual 2 ohm, wired series parallel to show the amp 2 ohms.2013 Outback V
05-04-2011, 12:46 PM #6
I've been running 2 10's for a while. Doubles your sound output! You'll need to crack open your seat to make it really work. Check my profile pics for more ideas.
I get a lot of complents and astonished looks when I crank it up. PM me with any questions you have about set-up. I've spent a lot of time figuring out the best configurations for that set-up.
PWI as usual...
05-04-2011, 11:49 PM #7
05-05-2011, 12:19 AM #8
05-05-2011, 09:56 AM #9
Yea, Ive had a lot of ideas but they are either expensive, perminent, or obtrusive.
- Adding heater vents to the walk-thru as ports (to match the existing ones.
- Adding 2 more cup holders to the dash with the bottoms cut out.
- Notching about a 3" gap along the bottom of the observer seat back. Kind of an Arc along the bottom.
- I've tried to figure a way to make a vent in the seat base but not sure how I would make that happen.
PWI as usual...
05-05-2011, 10:15 AM #10
Ever though if adding one of these in that gelcoat area kind of where the capacity sticker is. Is this sort of what you are looking for?-2012 Supra 21v
Wetsounds Rev10's, Wetsounds SYN 4, Wetsounds XS-12, Alpine MRP-M500,
JL Audio JX360/4, Polk MM651 Interiors
-2008 Mobius LSV