Results 31 to 40 of 100
-
05-31-2011, 09:08 PM #31
Mine has stayed solid, I've put about 12 hours on it, including 4 runs between 20-40 MPH (depending on water conditions) for 18 miles each - basically from the Southern end of Torch Lake to the Northern point, where L's cottage is.)
2013 Outback V
-
05-31-2011, 09:45 PM #32
-
05-31-2011, 10:05 PM #33
-
05-31-2011, 10:08 PM #34
-
05-31-2011, 11:16 PM #35
-
05-31-2011, 11:28 PM #36
x2 i guess i can return my stuff to lowes, since we surf and all.
dan, you got any picsLast edited by jmvotto; 05-31-2011 at 11:37 PM.
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
05-31-2011, 11:31 PM #37
-
05-31-2011, 11:35 PM #38
How about taking a feeler gauge, measuring the gap from the top one the transom side between the boat bracket and your platform bracket, then getting that thickness of ss metal or aluminum then cutting it to proper width and length , putting a bend on the top end then inserting it on the water side between your platform bracket and boat bracket. when you want to remove just tap up on the bend of the piece of metal..........I think some one already has this........just use a feeler gauge to determine the thickness and length you need
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
05-31-2011, 11:37 PM #39
-
05-31-2011, 11:39 PM #40
I found the link and posted it in the how to section Sandm has the metal shims
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug