Pop up Cleats?

[E4NASH]

Was wondering if any of you have added pop up cleats to your boat? My boat doesn't have them so I was thinking about adding them. I don't think they'd be that difficult to install. What do you all think?

[newty]

I've done them on other boats. Very easy!!! depending on which ones you buy you'll need a hole saw and maybe a small cut off wheel or jig saw. Oh... and a lot of painters tape.

Check Harbor Freight. they have them on the shelf here for <$10 a piece. They are decent quality too!

[kaneboats]

I installed 4 of them on my Outback. The hardest part was figuring out where to put them. I opted for slightly different from the standard front locations. I bought the wrong kind though and it made the install much harder. I had to drill holes and then cut a slit between a couple of them for the cleat to slide all the way down. Take a close look at what you are buying. You only want to drill, not saw, if you can help it. But, overall not a bad job. Just be sure to measure 10 times and cut once (or something like that).

Did a little looking:

https://forum.moomba.com/showthread.php?t=5834

[KSmith]

As usual, I took a different route and used these.

[11 Outback V]

You might want to look at the "push pin" style cleats. They a very similat to the ones KSmith has. All you need to do to install them is drill a hole. Very simple and low profile

Todd

[viking]

Cool ...... where'd u get em?

[KSmith]

Cool ...... where'd u get em?

I got mine at Overtons

http://www.overtons.com/modperl/prod...ils_box_holder

[E4NASH]

As usual, I took a different route and used these.

Yeah, I'm digging those!

[New Guy]

As usual, I took a different route and used these.

They look awesome I just might have to pick some up.

[WaterBullDawg1980]

As usual, I took a different route and used these.

Nice! I like those. I opted for the regular style. Wish I'd seen those!