Page 2 of 7 FirstFirst 1234 ... LastLast
Results 11 to 20 of 68
  1. #11
    Join Date
    Jan 2010
    Location
    North Texas
    Posts
    2,844

    Default

    A few more pics of the switches. These are ground interrupting switches. When the hatches are closed, the LED in said compartment turns off. These were added to all the lockers so no battery drain occurs. From the factory, the rear lights and locker light, and behind our driver seat came on at any time you turned the courtesy's on. Not any more!!!

    Both of these are "pre-cleanup." Dont think for a second we have a single wire showing!! HAhahaha

    Front Locker Switch

    Rear Locker Switch
    Last edited by dusty2221; 02-28-2011 at 12:14 PM.

  2. #12
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    7,692

    Default

    Great work Guys, Now i need a 24 fter...

    Under water leds to match.

    is that transom ski ring LED legal at night for drving????might draw some attention from the Po Po
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

  3. #13
    Join Date
    Mar 2010
    Location
    Arkansas
    Posts
    3,952

    Default

    Quote Originally Posted by jmvotto View Post

    is that transom ski ring LED legal at night for drving????might draw some attention from the Po Po
    I have had 1 run in with the popo in the last 10 years on the water and it was a life jacket and fire extinguisher check. So, honestly, it never crossed my mind.

    I can't remember if that light is tied in with courtesy or nav but i don't think it will cause any issues one way or the other.

    I'm sure they would spot us surfing before they saw the LED
    2016 Moomba Mojo
    2006 Supra 24SSV - Traded

  4. #14
    Join Date
    May 2009
    Location
    North End Lake Lanier GA
    Posts
    8,155

    Default

    Real nice looking guys i can tell you spent a lot of time on it and it shows. Good clean work indeed.
    Malo <--- Means--Evil or Mean One. This explains a lot.
    2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
    [COLOR="#696969"]

  5. #15
    Join Date
    Jul 2007
    Location
    Sun City, AZ
    Posts
    57

    Default

    OK...that is sick!!!! Well done!

  6. #16
    Join Date
    Apr 2008
    Location
    California
    Posts
    2,840

    Default

    Nice job guys! Great attention to detail, it shows.
    2007 Mobius LSV

  7. #17
    Join Date
    Jun 2008
    Location
    Henderson, NV
    Posts
    7,028

    Default

    nice install. looks clean.
    never been one that understands the led's everywhere(don't hang at the party cove), but it looks like you did a lot of planning rather than just throwing lights everywhere..

    nice job and tasteful
    '06 Supra Launch 20SSV-gone but never forgotten

  8. #18
    Join Date
    Mar 2010
    Location
    Arkansas
    Posts
    3,952

    Default

    The LEDs were almost the end of our friendship. Neither of us really "needed" them. We started with above cupholders and vents only bc we thought it looked cool. Once the Roswell was converted red it was pretty much over. We decided it needed to match so we replaced all factory lights with red and then added lights to all the other storage compartments, cause thats where you need them!

    Not alot of bling factor but alot of detail. Only visible light bulbs during the day are the drivers and bow cupholders and the floor lights (which are factory)
    2016 Moomba Mojo
    2006 Supra 24SSV - Traded

  9. #19
    Join Date
    Mar 2010
    Location
    Arkansas
    Posts
    3,952

    Default

    Found a couple more post worthy photos ...

    This is the bullet coaxial lit up





    Another cockpit pic



    and a zoomed out amp rack pic ...




    And THANKS for all the comments guys! It means a lot after all the thought and work put into.
    Last edited by KG's Supra24; 02-28-2011 at 03:48 PM.
    2016 Moomba Mojo
    2006 Supra 24SSV - Traded

  10. #20
    Join Date
    Feb 2008
    Location
    Traverse City, MI
    Posts
    2,680

    Default

    That looks awesome - makes me want to re-build mine, again, lol!

    What did you use for LED in the speakers, and where did the hatch switches come from?
    2013 Outback V

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •