Results 1 to 10 of 21
-
02-27-2011, 10:21 AM #1Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
2000 Moomba Outback Died While Running
When we took our boat out at the launch, it started fine... was idling rough but stayed running. Got out on the lake idling, doing ok. But when we tried to speed up a little, the boat died. It wouldn't crank, starter won't turn. Tried jumping the starter to crank, but it wouldn't do anything. Also tried tapping on the starter, but got nothing. The boat is getting gas. Electrical is completely dead. All the gauge positions stayed right were they were at (at running) and wouldn't reset even when boat was shut off. Any ideas what the problem might be? Thank you!
-
02-27-2011, 12:36 PM #2
Not sure , but do you remove your speedo pick up lines off your mdc during winterization?
09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
Doug
-
02-27-2011, 01:18 PM #3
Did you hit the master reset button on the back of the engine? Did you check the lanyard? Are you saying the engine won't turn over at all? Or are you saying it will turn over but just not start? Please clarify. We can probably help but you have to be very specific.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
02-27-2011, 04:12 PM #4
Does it have the Lanyard kill? Check that too!
2007 Moomba Outback - going, going, GONE
2015 "NOT A MOOMBA"
Why Not? Play Hard! Get wet
-
03-01-2011, 08:54 PM #5Banned
- Join Date
- Oct 2005
- Location
- Durham, NC
- Posts
- 649
It might be a long shot, but mine died kind of like that once. It turns out, I had knocked one of the electrical leads off the back of the key switch, and it killed everything. My heart stopped for a minute until I found out what it was.
-
03-05-2011, 08:25 PM #6Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
-
03-05-2011, 08:27 PM #7Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
Last edited by SPJP; 03-05-2011 at 08:37 PM.
-
03-05-2011, 08:28 PM #8Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
-
03-05-2011, 08:29 PM #9Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
-
03-05-2011, 08:33 PM #10Junior Member
- Join Date
- Feb 2011
- Location
- Litchfield, Michigan
- Posts
- 13
Thank you for all your advice
We have never had any major problems with this boat. Replaced the starter, had to have the packing replaced, and blew a head gasket once, but the head gasket is ok now. It has been an awesome boat. This is the first time anything like this has happened. Can't wait for Spring to break so we can get it back out on the lake again. Thank you all very much for any advice. We will check everything out you suggest.