Results 1 to 3 of 3
Thread: Need Help Wiring!!
-
11-27-2010, 11:22 PM #1Member
- Join Date
- Feb 2010
- Posts
- 54
Need Help Wiring!!
hi there guys, i have a 1800 watt kenwood amp and 2 10 inch punch dual voice coils subs. i would like someone help me with wiring them. i do not know a whole lot about ohms and stuff like that.
here is the link to the specs on my amp:
http://www.sonicelectronix.com/item_...mpaign=froogle
here is the link to the subs. i have 2 of them:
http://www.rockfordfosgate.com/produ...n_US&p_status=
thanks!!!
-
11-28-2010, 10:47 PM #2
Wire each 2-ohm DVC sub in series, this will give you two 4 ohm subs. Then wire the two subs in parallel, this will give you a 2 ohm load at the amp for 900 watts rms.
-
11-29-2010, 12:04 AM #3
Follow the link to your sub. Click on the wiring wizard tab. Follow the wiring configuration for two subs that results in a 2 ohm total load. This will deliver 450W rms to each sub so be careful with the volume since they are only rated 250W rms per sub.
Last edited by cab13367; 11-29-2010 at 12:07 AM.
Al
2006 Mobius LSV