Tower mount keeps comming loose

[bjames]

OK... I am getting real tired of my front port side tower mount comming loose after every ride . This is where the detachable foot mounts to the tower leg. There is a set screw that keeps comming loose - even when I use blue lock tight. The set screw was replaced under warranty early in the season, however that doesnt seem to be the cause. Right now I have a 1/8" gap between the tower leg and tower foot and moves up and down until I re-tighten the set screw. The other side is tight and never had a problem. Any sugestions?

[lewisb13]

RED Loctite or bowstring wax

[bjames]

if it's a nyloc, get new ones

What do you mean? Nylon set screw? This is a small stainless set screw. I am starting to wonder if the threads on the tower are stripped. Under close inspection, the threads on the SS screw is good, but sits crooked inside the hole.

[cab13367]

What do you mean? Nylon set screw? This is a small stainless set screw. I am starting to wonder if the threads on the tower are stripped. Under close inspection, the threads on the SS screw is good, but sits crooked inside the hole.

That's pretty lame if a small set screw is the only thing holding the tower tube to the foot. And a safety issue as well. Or maybe I am not understanding it correctly.

How about drilling all the way thru the tower leg, both the inside and outside tubes, and securing it with a SS screw and nylock? Be careful if you have wires running thru there though.

Glad my 2006 is welded there instead of being removable

[bjames]

That's pretty lame if a small set screw is the only thing holding the tower tube to the foot. And a safety issue as well. Or maybe I am not understanding it correctly.

How about drilling all the way thru the tower leg, both the inside and outside tubes, and securing it with a SS screw and nylock? Be careful if you have wires running thru there though.

Glad my 2006 is welded there instead of being removable

I agree, it is lame... seems like one more point of posssible faillure. I was told that the detachable tower feet are an option and is comonly used so that the dealer can ship the boats with the towers off, and assemble them a lot easier once they arrive.
I was wondering the same thing about drilling through. Besides, Im pretty sure a thru-bolt would be a more secure method of attachment.

tower foot.JPG

[DOCDRS]

Yours is similar to mine the coollar and the swivel are a unit that is welded to the tower
I was told there is a large bolt and washer of some sort on the swivel that will
Not let it separate from the coller

[DOCDRS]

I have a. Smilar prob, will post pics later, and made a post about this. Ihave talked to
Cody at. XTP , it is used to help them mount the towers. To hold the swivel, my boat was
missing these on 3 of the feet and I only noticed as the one
Present was squeeling like a pig in rough water. Mine are on the inside close to the window
Any ways thinkinhg about this what if a hole was drilled thru the tower collar and swivel then
Bolted with lock washer