1st of all I was told I would be fine running these speakers @ 2ohm, which if im figuring correctly will yeild me 215 watts @ each of the 4 speakers. However I was also told that it is possible that my speakers could be dropping the load to under 2 ohm which is not good for the amp. I am assuming it is necessary to run my set up @ 2ohms to get enough power to push the speakers to their potential. If its not gonna yield much more audible power I guess I will wire them back to 4 ohms to save possible wear on the amp. Any advice?

This is the descriptions of my amp/speaker setup.


Kicker ZX850.2
ZX Series 2-Channel Class AB Car Amplifier
RMS Power Rating:
4 ohms: 295 watts x 2 chan.
2 ohms: 425 watts x 2 chan.
Bridged, 4 ohms: 850 watts x 1 chan.
Max power output: 850 watts x 2 chan.



Krypt 8" HLCD (4 of these speakers)
Nominal Diameter 8 inch
Nominal Impedance 4 ohm
RMS Power 180 Watts
Peak Power 360 Watts
Sensitivity (1w/1m) 93 dB
Frequency range 60 - 20K Hz