Results 1 to 3 of 3
Thread: no power to coil
-
06-27-2010, 06:12 PM #1
no power to coil
2007 Mobius LSV
Went to Wakeboard today and tried to start the boat and it would crank but not start. I started with ignition only to find no fire coming from the coil. So I checked power to the coil and I didn't have any power at the coil. I checked the circuit breaker at the motor and it was good. I also checked the three fuses in the fuse holder and the 35 amp large fuse. All checked out fine. My initial though was the Ignition Control Module but not sure. Any input would be great. Actually a wiring schematic would be very helpful as well. Thanks2007 Moomba Mobius LSV 3000lbs Ballast. 2009 Ronix One board 138 and Ronix 2010 One Bindings
-
06-28-2010, 08:46 AM #2
Be sure and check the lanyard/kill switch.
My Mom said I'm not allowed to get wet!
2008 LSV (sold)
2000 Outback LS (sold)
LLTR!!!!!!!!
-
06-28-2010, 09:02 AM #3
Checked the kill switch first thing. Thank
2007 Moomba Mobius LSV 3000lbs Ballast. 2009 Ronix One board 138 and Ronix 2010 One Bindings