Results 1 to 6 of 6
Thread: How to Remove Seadek
05-17-2010, 07:54 PM #1
How to Remove Seadek
Ok so this subject will come up sooner or later so i'll post a solution now.
I had placed 3mm Cool Gray Seadek strips on my gunwale tops to use as step pads. Worked real well except that 3mm is not thick enough imo so i wanted to remove and try some 5mm Storm Gray. So i started to remove it and it leaves behind a very tacky glue surface that nothing seems to remove!
Researching the Seadek site i found a comment about using mineral spirits, let it site for 10 minutes then remove that with acetone. Worked like a charm without issue. Re-wax the surface and your done.2007 Mobius LSV
05-18-2010, 01:42 PM #2
try Goof Off much stronger than goo gone. but mineral spirits is much cheap i believe.
Ed, just make sure the gasoline is not from the two cycle weed wacker can.A Day at the Lake...Priceless
A Day in Powder...Endless
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
05-18-2010, 02:39 PM #3
Neither Goof Off or Goo Gone will remove it, trust me. Now gas probably will take it off but i didn't want to use gas on the gelcoat so close to the upholstery. Not to mention using gas isn't exactly the safest method now is it?2007 Mobius LSV
05-18-2010, 03:31 PM #4
05-23-2010, 11:23 PM #5
05-23-2010, 11:52 PM #6
Funny. I'm drinking my brother's homemade beer tonight. It's a little varnishy, but I'm not removing a pad. Oh well.My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)
P5 Danielo Diamond 58"