Diamond Plate Kit For Trailer

[stretch55]

Just thought that I would throw this out to the fellow members. First let me say that I am not an agency or an agent for any angency. I am just a normal guy looking for some extra gas and beer money for the upcoming season. I am offering a full diamond plate sytem for the boat trailer. What this system does is replace all of the black rubber padding on the trailer now with nice looking diamond plate.

This kit will include:
1-Bow stop pad
1-Jack pad
1-Swing tounge pad
2-Fender pads (1 left & 1 right)(specify width length will be 36")
2-Front step pads (1 left & 1 right)(20" or 23" please specify)
2-Rear step pads with guide post holes (1 left & 1 right)(34" or 39" please specify)
Please note you will have to 3M them or pop rivet them on. (I pop riveted mine on) but it is personal preference and what is evre available to you.


I am doing these kits as follows:
$150.00 for double axle trailers shipped to the US 48
$125.00 for single axle trailers (since there are no fender pads) shipped to the US 48

If you ordered just all black rubber replacements from boatmate it would run you about $180.00 + shipping.

I need at least 2 orders to get the ball rolling please PM me if you are interested. All payments and shipping info will be done through PayPal.

[cab13367]

All,

I have seen stretch's trailer in person and the diamond plate step plates was the first thing I noticed. I checked them out closely and I can attest to the quality of stretch's work - it absolutely looks factory. Stretch works with architectural sheetmetal for a living so you can bet the quality will be top notch.

[cab13367]

BTW, I'd like to be your first customer - I'll take a set!

[you da man]

What's the adhesive that's securing these? I'm 99% sure I'm in for a set.

[RobertJ]

I have a single axle trailer I would be in if you could make make the fender steps for it. I live in Salem.

[gus 08 mobius lsv]

i may be interested in this as well!

[mmandley]

I also seen these on Stretch's trailer and they are realy nice. The pictures dont so it justice.

I might have 6 polk cabins for trade buddy LOL.

Ill get in touch with you LOL

[stretch55]

What's the adhesive that's securing these? I'm 99% sure I'm in for a set.

No adhessive on it. As I stated at the start of the thread you would have to 3M adhess it or pop rivet it (if you have a drill, 1/8" drill bit and a pop riveter).

[stretch55]

i may be interested in this as well!

Ok buddy just let me know.

[rc5695]

Those look great! Great price too!

For the rear, do they slide down over the boat guides? I know the guides on my older (2000) trailer are welded on, and have a ring welded on them so the plastic stays up where it is supposed to. It looks like your diamondplate is pretty close to the same size as the guide at the bottom. Might just be the picture though?

Is it aluminum or SS? What is the thickness?

Thanks, Ryan