Results 11 to 15 of 15
Thread: Tower Issues
04-01-2010, 03:55 PM #11
I second pretty much what everyone else said with a small addition. When I bought my Monster Tower cans with the Polk DB650's, they recommended at least 100w per speaker, even though they are rated for like 60 w RMS or something like that. So I bought a RF Punch 400.2 (I think it is) and I have my 4 speakers wired in parallel off the two channels so the amp is seeing a 2 ohm stereo load and each speaker is getting 100w RMS. It is pretty loud and you can it hear back behind the boat riding, but the whole setup is still sub-optimal to be honest. To get it loud at 70 feet it has to be turned up until it almost distorts, and then it is so lound in the boat, folks ears are almost bleeding.Brian Roberts
2001 Outback DD
04-01-2010, 04:22 PM #12
If I read right, you moved the head unit's yellow power wire to the amp, but left the red power wire in the console wiring? Moving one without the other can cause the problem you describe... It can happen because your head unit is now potentially/possibly getting its power from two different batteries if you have a dual battery setup, and/or the red power wire is still getting a bunch of noise on it from other items connected to the same power at the helm, and it is at a slightly different voltage potential from the yellow power wire. You need the red wire at the same power source as the yellow wire...
Double-check that or clarify for me; you might have just described the primary reason for your alternator whine...
04-03-2010, 07:51 PM #13
sounds like you have the wining whan the altanator is charging, this a ground problem or you are running your power wires by you charge wire. if the noise is gone when you unplug the rcas you can run a ground loop icolator on your tower rcas this will stop it and they are prittttttty cheep. you can get them at large sterio shops
04-04-2010, 09:22 PM #14
I did get up there and put the new amp in and messed around a bit with it, but didnt have time to wire the red wire to the battery like you mentioned. Its easy enough to do, but I kinda forgot when I was up . I am going to do it next time I go up I will have alot more than 3 hours for everything.
I did check the speakers and they seem ok at low level didnt hear any crackling or anything weird from the tweeters!!! so that's a positive. I looked over the speaker wire where the wires go into the tower and come out they look good not worn at all either...
I pulled the antenna with the radio on and ignition on and it didnt change anything either
One question I kinda had was I am using some AMP 10 pin connectors for the through hull and then into my tower box would those mess up the signal at all ? or probably not?
And if I hook up the red power and the whine is gone which it sounds like a high possibility it will be... Should I run the wire straight to the rocker switch and the straight back to the deck? I want the radio to be switched on and off with the stock rocker
Last edited by c.rix; 04-04-2010 at 09:26 PM.2007 Outback V
04-05-2010, 10:06 AM #15
Yeah, for a rocker switch installation, run a red wire from the amp's +12v power lug, up to the switch, and then to the radio. I have attached a pic showing this. Just to be safe, you want a fuse on that small power wire going from the amp to the switch, as shown.
The picture shows a single wire going to the "front-end" of the switch, with a yellow wire coming off from there; you can disregard that, (hopefully!) as you already have your yellow wire run properly.
I f you have any questions, feel free to holler, via PM or reply. I bet we can get that whine gone, even with that amp.