Search:

Type: Posts; User: LSM

Page 1 of 3 1 2 3

Search: Search took 0.10 seconds.

  1. Replies
    9
    Views
    1,235

    Let me know if it doesn't work out. Thanks

    Let me know if it doesn't work out. Thanks
  2. Replies
    9
    Views
    1,235

    Did you sell the cover? I may consider it if you...

    Did you sell the cover? I may consider it if you still have it.
  3. Thread: Need 06 lsv Bimini

    by LSM
    Replies
    2
    Views
    686

    I have a factory bimini for an 06 LSV that I will...

    I have a factory bimini for an 06 LSV that I will sell. I took it off this past Feb. only to replace it with a cargo top. There is nothing wrong with it. It's just sitting in my garage. Make me...
  4. Replies
    6
    Views
    1,246

    I don't have the answer to your questions but I...

    I don't have the answer to your questions but I do have a 06 LSV bimini like you describe. It's gray. I'm willing to selling it as I don't use it anymore. You could use parts from it to fix yours....
  5. Thread: Cleats?????

    by LSM
    Replies
    16
    Views
    1,825

    I have an 06 myself. Mine has the factory pop-up...

    I have an 06 myself. Mine has the factory pop-up cleats....
  6. Replies
    4
    Views
    648

    I have a factory Grey bimini for an 06 LSV that I...

    I have a factory Grey bimini for an 06 LSV that I do not need. I'm not sure if it will fit your boat or not. The LSV changed in 06.
  7. Thread: LSV Tracking fins

    by LSM
    Replies
    5
    Views
    989

    My 06 has 3.

    My 06 has 3.
  8. Replies
    7
    Views
    1,018

    I too have the same engine in an 06 LSV and I can...

    I too have the same engine in an 06 LSV and I can get 43 or so with 2 adults and two kids on flat water....

    I can also get 39-40 with 4 adults and two kids if I need too but I rarely run it that...
  9. Thread: Hit a Stump

    by LSM
    Replies
    15
    Views
    1,433

    I've owned a Malibu, a Master Craft and Now an 06...

    I've owned a Malibu, a Master Craft and Now an 06 Moomba LSV plus I've looked at serveral others and I've never seen nor heard of one that is supposed to bent to the left. I feel certain that the...
  10. Thread: Hit a Stump

    by LSM
    Replies
    15
    Views
    1,433

    If you ran it out of water you may be able to...

    If you ran it out of water you may be able to learn something if you could watch the prop spin. Maybe....depending on how bad it's bent.

    I've not done that before. I'm sure the vibration would be...
  11. Thread: Hit a Stump

    by LSM
    Replies
    15
    Views
    1,433

    One thought..... I know you are looking at the...

    One thought.....

    I know you are looking at the prop but make sure you look at the base or near the base of the prop as well. Not just the tips. If one blade got hit near the base it could've...
  12. Thread: Hit a Stump

    by LSM
    Replies
    15
    Views
    1,433

    http://www.skidim.com/products.asp?dept=1123 ...

    http://www.skidim.com/products.asp?dept=1123

    Your not going to like the price though....It's nearly 400 bucks.

    I guess it is possible that the bent rudder is causing some sort of turbulance but...
  13. Replies
    15
    Views
    2,368

    Sorry been busy the past few weeks.... I don't...

    Sorry been busy the past few weeks....

    I don't recall the manufacturer of the failed axle either....
  14. Thread: Hit a Stump

    by LSM
    Replies
    15
    Views
    1,433

    Sorry to hear your trouble..... It may be hard...

    Sorry to hear your trouble.....

    It may be hard to tell if its the prop or the shaft or both. The slightest issue with the drive shaft or prop will cause vibration. Any vibration is not good. I...
  15. Replies
    21
    Views
    2,013

    I'm not aware of a recall but Boat Mate does have...

    I'm not aware of a recall but Boat Mate does have some defective axles that went out on trailers over the past 4 or 5 years. I had one fail, contacted BoatMate and they were aware of the issue. ...
  16. If the water level in the hull got so high it got...

    If the water level in the hull got so high it got into electrical cables that could cause problems. If you had your bilge pump on auto it should've been pumping continously if you had that much...
  17. Replies
    15
    Views
    2,368

    My Marathons were also bad. I have an 06 LSV. ...

    My Marathons were also bad. I have an 06 LSV. Those tires always buldged no matter the air pressure. They were load range D. In my opinion that is not enough tire for a LSV sitting on a single...
  18. Replies
    9
    Views
    848

    Same problem at the rear seat location on my 06...

    Same problem at the rear seat location on my 06 LSV. I'd like to see you press them to cover it under warranty. This should not be an issue on a new boat.
  19. I hate you had the problem but I'm glad that...

    I hate you had the problem but I'm glad that fixed it. - and it was a cheap fix too..
  20. Replies
    18
    Views
    1,798

    I contacted my dealer regarding a tandem axle...

    I contacted my dealer regarding a tandem axle trailer and he basically told me good luck or $5,000 dollars for a new one. He also told me that he would not take a trade for my single axle.

    I...
  21. Replies
    0
    Views
    462

    Wanted: Tandem Axle Trailer for 06 LSV

    I have on 06 LSV that is on a single axle trailer. I'd like to find a tandem axle trailer that fits my boat. A dealer gave me a price of 5000 bucks. If any one knows of a better place to get a new...
  22. If you get 2 plug wires crossed somewhere it will...

    If you get 2 plug wires crossed somewhere it will do the exact same thing.......Ask me how I know. It'll sound great out of gear but when you load then engine it'll run weak and back fire...I had an...
  23. Replies
    8
    Views
    1,520

    My boat is an 06 LSV. I have the original tower...

    My boat is an 06 LSV. I have the original tower bimini in my garage. I don't use it any more as I've installed the Monster Cargo top. It is grey though, I'm not sure how that would look on yellow.
  24. Replies
    24
    Views
    3,138

    Thanks, They are not factory but I actually...

    Thanks,

    They are not factory but I actually like them better than factory. I spent several days on the phone and online with Chris P of Phunkin Good Times. He and I worked together to come up...
  25. Replies
    24
    Views
    3,138

    I took my decal off as well, but I decided to go...

    I took my decal off as well, but I decided to go back with two new ones......

    Here are pics of mine with the old decal then the new ones I put on last month....
Results 1 to 25 of 61
Page 1 of 3 1 2 3