Search:

Type: Posts; User: Antoine

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    7,613

    After a little bit of research, I think that my...

    After a little bit of research, I think that my first course of action will be to change the bushings in tje motor mounts. It is pretty clear that one of them has completely collapsed and the othe...
  2. Replies
    6
    Views
    7,613

    I forgot to mention, It’s a mobius lsv 2009 with...

    I forgot to mention, It’s a mobius lsv 2009 with indmar 325 and walter v-drive.

    Thanks
  3. Replies
    6
    Views
    7,613

    These are my motor mounts. They are not the same....

    These are my motor mounts. They are not the same. Is this normal ?

    3103331034
  4. Replies
    6
    Views
    7,613

    My engine is sitting on the bildge

    Hi guys,

    I was trying to look at the shaft alignement when I noticed that my transission is sitting on the fiberglass hump where the shaft comes in and that my oilpan drain plug is only 1/8 of an...
  5. I figured it out. Let me know if l am wrong. ...

    I figured it out. Let me know if l am wrong.

    I ordered 2 RCA y spliters and i will be able to feed my 4 channels amplifier with front left and front right each doubled so that the amplifier will...
  6. Thanks I will install a second amplifier as you...

    Thanks I will install a second amplifier as you suggested.

    I am using the fader control of my equilizer to switch between in-boat and tower. How will i connect only one imput (front=tower) to one...
  7. Witch 2 chanel amp would you recommend????

    Witch 2 chanel amp would you recommend????
  8. In your opinion, will ot be ok, or i will need to...

    In your opinion, will ot be ok, or i will need to buy a new amplifier as well???
  9. Tower speaker replacement and wiring question

    I just bought 2 new kicker KMS67 tower speakers to replace older blown out current speakers. I will keep the same pods

    The speakers are rated at 4 ohms 200 RMS

    My amplifier is 4 chanels x...
  10. Replies
    3
    Views
    996

    It's about 24 inches from the ruder connection in...

    It's about 24 inches from the ruder connection in the engine compartment.
  11. Replies
    3
    Views
    996

    Knocking in the steering?

    Is this normal,

    Occasionally, I will get a knocking vibration in the steering wheel when I first get going. It happens when the steering is not straight and I am pulling a surfer. After a few...
  12. Replies
    3
    Views
    2,190

    One of the brackets holding the bench to the...

    One of the brackets holding the bench to the floor didn’t have screws in. With the pressure, the bag lift the bench and ruptured against the sharp l shaped bracket.


    Envoyé de mon iPhone en...
  13. Replies
    3
    Views
    2,190

    I just realized that the boxes are...

    I just realized that the boxes are timer/controller. Do you think that one of them could be the problem?


    Envoyé de mon iPhone en utilisant Tapatalk
  14. Replies
    3
    Views
    2,190

    Ballast pump starting on it’s own

    One of my ballast pump will start filling when i am away from the boat, even if the ignition is off and the key is out. It burst the IBS and almost swamped the boat. Fortunately between the bildge...
Results 1 to 14 of 15