Search:

Type: Posts; User: gcnettl

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    21
    Views
    7,107

    That looks like the OE seal that I had. The...

    That looks like the OE seal that I had.

    The GLIDE seal had a plastic shaft like your aluminum one. It was installed in the seal, and when you installed the seal onto the boat shaft, the boat...
  2. Replies
    21
    Views
    7,107

    I couldn’t find any replacement parts for my...

    I couldn’t find any replacement parts for my seal. I purchased a GLIDE dripless seal from skidim, replaced the motor mount bushings, aligned the motor to the shaft, all is well. I suggest alignment...
  3. Replies
    4
    Views
    1,031

    Call the folks at skidim. They may can point you...

    Call the folks at skidim. They may can point you in the right direction.
  4. Replies
    7
    Views
    1,656

    I agree on the thermostat. I’ve never seen the...

    I agree on the thermostat. I’ve never seen the closed system so I don’t know how they operate.
  5. Replies
    5
    Views
    1,161

    Alignment of the motor to the shaft. Shaft needs...

    Alignment of the motor to the shaft. Shaft needs to be centered in the shaft log. Motor mounts need to be looked at and bushings replaced if extrusion of the rubber bushing is occurring. Check you’re...
  6. Replies
    4
    Views
    835

    Research vapor locking sounds like a potential...

    Research vapor locking sounds like a potential problem/solution whichever way you look at it. Make sure batteries cable terminals are tight and not corroded. Doubtful since it runs fine on startup...
  7. Replies
    7
    Views
    2,990

    Put the boat in the water and turn the bilge pump...

    Put the boat in the water and turn the bilge pump on. Start looking around for leaks. Look at the places mentioned already. That much water will not be hard to spot. Also make sure your water jacket...
  8. Replies
    7
    Views
    1,656

    Thermostats can and do fail to open. Pretty...

    Thermostats can and do fail to open. Pretty simple and cheap to replace.
  9. Replies
    21
    Views
    7,107

    Seal on my Mojo is pouring water. I pulled the...

    Seal on my Mojo is pouring water. I pulled the dripless seal off. The rubber inside the brass is worn causing the water to come out. My question, in all the images I have seen, there is always a...
  10. Replies
    9
    Views
    2,664

    I am guessing that the dealer had the powder coat...

    I am guessing that the dealer had the powder coat put on as an option. Only thing you can do is get him to make good on it. As my rule, I do not buy anything with an aftermarket powder coat.
  11. Greasing once a week is a bit much, you will...

    Greasing once a week is a bit much, you will cause grease to escape the seal and that is why you had grease all over your brakes. When was the last time you pulled your hub off your truck and re...
  12. Replies
    9
    Views
    4,346

    Since you replaced the separator, then you prob...

    Since you replaced the separator, then you prob still have bad gas in the lines and bowl of the carb. You could try to start it using some ether(starting fluid) by spraying it into the carb while...
  13. Replies
    26
    Views
    6,310

    with that much water oil should have looked...

    with that much water oil should have looked "milky" when you checked it?
  14. Replies
    9
    Views
    2,827

    You know I was in need of some parts for my...

    You know I was in need of some parts for my utility trailer and I found a company that supplies such, leaf springs, axles, brakes, a good selection. I saw that they have 8,000 # torsion axles,...
  15. Thread: literature

    by gcnettl
    Replies
    2
    Views
    955

    I dont know of a manual such as you are looking...

    I dont know of a manual such as you are looking for.

    As a suggestion find a boat like yours and take pictures of everything. But that is not much of a suggestion.

    Sounds like what you need...
  16. Replies
    27
    Views
    9,071

    If this just started happening, and you know you...

    If this just started happening, and you know you have not run the engine overheated, then more than likely it is the exhaust flappers. If you get no smoke while running, then it sounds like water is...
  17. Replies
    27
    Views
    9,071

    Does it smoke while running?

    Does it smoke while running?
  18. Replies
    1
    Views
    1,394

    I put this light on my mobius....

    I put this light on my mobius.
    http://www.walmart.com/ip/LED-BI-COLOR-BOW-LIGHT-WH/11071198

    The picture does not do it justice. It is in no way a circular type light, it has a sleek shape to it.
  19. Depends on how full your ballast is, how full...

    Depends on how full your ballast is, how full your gas tank is, it will get totally under water though and you wont be able to see it, I do know that much as I have seen it happen.

    Mine prob....
  20. Replies
    5
    Views
    1,475

    Does your engine run rough and then die, or just...

    Does your engine run rough and then die, or just like you were running fine and then turned the ignition off?
  21. Replies
    9
    Views
    2,827

    Must have done some sweet sweet talking. My axle...

    Must have done some sweet sweet talking. My axle broke going through atlanta and boatmate laughed.
  22. Replies
    9
    Views
    2,827

    How much did your new axle cost if you don't mind?

    How much did your new axle cost if you don't mind?
  23. Thread: bow light

    by gcnettl
    Replies
    7
    Views
    5,366

    I am pretty sure I got mine from wal mart. Looked...

    I am pretty sure I got mine from wal mart. Looked better than the one that was in there. A quick search and sure enough they still carry it....
  24. Thread: Carb issues

    by gcnettl
    Replies
    6
    Views
    2,390

    You can call holley directly and they can get you...

    You can call holley directly and they can get you the number for the rebuild kit or carburetor. This is the route I went, but never actually got around to rebuilding mine. Symptoms have since resided...
  25. Replies
    5
    Views
    3,714

    I would like an answer on this one... PP has...

    I would like an answer on this one... PP has great customer service, just have not had the time to get them on the phone and be at my boat to troubleshoot. Mine gives a true MPH reading while PP is...
Results 1 to 25 of 160
Page 1 of 7 1 2 3 4